Removal Procedure
- Remove the handle assembly. Refer to [ADD LINK]..
- Remove the endgate trim panel. Refer to [ADD LINK].
- Remove the endgate bellcrank rod from the endgate inside handle assembly.
- Remove the fasteners that secure the endgate cover to the endgate.
- Remove the endgate cover.
- Release the endgate latch rods from the latch rod clips.
- Drill out the rivets that secure the handle assembly to the endgate.
- Remove the handle from the endgate cover.
Caution: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
Installation Procedure
- Install the inside handle assembly to the endgate cover using 2 rivets. [ADD CORRECT RIVET TYPE]
- Install the endgate bellcrank rod to the endgate inside handle assembly.
- Secure the endgate latch rods to the latch rod clips.
- Install the endgate cover to the endgate.
- Install the fasteners in order to secure the endgate cover to the endgate.
- Install the endgate trim panel. Refer to [ADD LINK].
- Install the handle assembly. Refer to [ADD LINK].
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 1.2 N·m (11 lb in).
