Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Important: Check the injector assembly to insure the O-rings have been removed.
Important: Remember to install the new O-rings into the inlet and outlet of the fuel injector assembly, using the seal retainer tool.
Tighten
• | Tighten the rear fuel line bracket bolt to 6 N·m (53 lb in). |
• | Tighten the fuel pipe retainer nuts to 3 N·m (27 lb in). |
Tighten
Tighten the nuts to 30 N·m (22 lb ft).
9.1. | Turn the ignition switch to the ON position for 2 seconds. |
9.2. | Turn the ignition switch to the OFF position for 10 seconds. |
9.3. | Again, turn the ignition switch to the ON position. |
9.4. | Check for fuel leaks. |