GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Generic 🢒 2002 🢒 Unit Repair 🢒 Engine 🢒 Engine Controls - 5.0L and 5.7L 🢒 Crankshaft Position System Variation Learn
  1. Connect the scan tool.
  2. Apply the vehicles parking brake.
  3. Block the drive wheels.
  4. Close the hood.
  5. Place the vehicles transmission in Park (A/T) or Neutral (M/T).
  6. Idle the engine until the coolant temperature reaches 65°C (150°F).
  7. Turn OFF all the accessories.

    8. Important: If the CKP System Variation Learn Procedure cannot be completed successfully, refer to DTC P1336 for additional diagnostic information.

  8. Enable the Crankshaft Position System Variation Learn Procedure with the scan tool.

    9. Important: After the ignition switch is turned to the CRANK position, the powertrain control module (PCM) must see a change in the state of brake switch (Released to Applied) to run the learn procedure. Also, the service brakes, not the parking brake, must be held throughout the duration of the learn procedure.

  9. Apply and hold the service brakes.

    10. Important: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine control is returned to the operator and the engine will respond to throttle position after the learn procedure is complete.

  10. Slowly raise the engine speed to 4000 RPM.
  11. Immediately release the throttle when the engine speed decreases.
  12. Turn OFF the ignition for 15 seconds after the learn procedure is completed successfully.