Electronic Throttle Actuator Control Module Replacement for Generic Unit Repair 2003

1. Turn the ignition OFF.
2. Unclip the lower trim panel and remove the panel.



3. Remove the center air duct (1).



4. Remove the two TAC module attachment nuts from the right mounting studs (3, 4).



5. Remove the TAC module attachment nut from the left mounting stud (1).



6. Remove the TAC module from its I/P bracket enough to allow easy removal of the two electrical connectors.
7. Disconnect the TAC module electrical connectors (1, 2) and remove the TAC module.

1. Install the TAC module and attachment nuts on the right TAC mounting studs (3, 4).



2. Install the TAC module attachment nuts on the left TAC mounting stud (1).

Tighten
Torque all of the mounting nuts to 4 N·m (35 in lbs).




3. Connect the TAC module electrical connectors (1, 2).



4. Install the center air duct (1).
5. Install the lower trim panel.