Rear Object Alarm Module Replacement Escalade EXT

1. Lift the left rear seat up to gain access to the electronic suspension control module and rear object alarm module container.
2. Remove the cover retainers from the seat frame and discard if damaged.
3. Slide the container assembly from underneath the seat frame.
4. Lift the cover off (1) by pushing in where the tabs on the cover locks.



5. Disconnect the electrical connector (1) from the rear object alarm module (2).
6. Push away the tabs from the module in order to lift the module out.
7. Remove the module (2) from the container.

1. Install the module in the container by pushing on the module until it locks in place.
2. Connect the wire connector to the alarm module (1).



3. Installed the cover (1) by pushing on it until it locks in place.
4. Slid the container under the rear seat frame.
5. Install a new cover retainers to the seat frame.
6. Set the rear seat to its original position.