Tools Required

1. Remove the transaxle. Refer to Transmission Replacement .



2. Use the J 37096 to secure the flywheel in order to prevent the crankshaft from rotating.



3. Loosen the 8 engine flywheel bolts.
4. Remove 7 of the 8 engine flywheel bolts, leaving one bolt at the top of the crankshaft rotation.
5. Firmly grasp the engine flywheel and remove the remaining bolt. Do not drop the engine flywheel when removing the final bolt.
6. Remove the engine flywheel.

1. Install the engine flywheel.
2. Use the J 37096 to secure the flywheel in order to prevent the crankshaft from rotating.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the new engine flywheel bolts.

Tighten

1. Tighten the engine flywheel bolts to 15 N·m (11 lb ft).
2. Use the J 45059 to rotate the engine flywheel bolts an additional 50 degrees.
4. Measure the engine flywheel runout:

4.1.	Install a dial indicator on the engine block and check the engine flywheel runout at three attaching bosses. Refer to Engine Mechanical Specifications .

4.2.	If the condition cannot be corrected, replace the engine flywheel.

5. Install the transaxle. Refer to Transmission Replacement .