Blower Motor Control Module Replacement for Generic Unit Repair 2006

1. Remove the right side instrument panel (I/P) insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages, and Console.



2. Disconnect the electrical connector from the blower control module.
3. Remove the 2 heat stakes from the blower control module using a small chisel.
4. Remove the blower control module.

1. Install the blower control module.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the 2 new screws in the pre-drilled holes to the side of the heat stakes in the blower control module and the HVAC module assembly.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).




3. Connect the electrical connector to the blower control module.
4. Install the right side I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side in Instrument Panel, Gages, and Console.
5. Refer to Control Module References for programming and setup information.