GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Generic 🢒 2006 🢒 Unit Repair 🢒 Accessories 🢒 Keyless Entry 🢒 Remote Vehicle Start Inoperative

Diagnostic Aids

The remote vehicle start (RVS) will not operate under the following conditions:

    • The hazard switch in the ON position.
    • A hazard switch diagnostic trouble code (DTC) is set.
    • The vehicle hood is open.
    • A hood ajar switch DTC is set.
    • An automatic transmission shift lock control system DTC is set.
    • The ignition key is in the ignition.
    • A vehicle speed signal is detected by the engine control module (ECM)/powertrain control module (PCM).
    • A vehicle DTC that illuminates the malfunction indicator lamp (MIL).

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. The remote start enable procedure is contained in the Starting System Description and Operation.

Step

Action

Yes

No

Schematic Reference: Keyless Entry Schematics

Connector End View Reference: Keyless Entry Connector End Views

DEFINITION: The remote vehicle start function does not operate.

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Turn ON the ignition, with the engine OFF.
  2. Press the driver information center (DIC) Options button until Personal Programming appears on the display.
  3. Press the Set/Reset button.
  4. Press the Options button until Remote Start appears on the display.
  5. Is the Remote Start option is enabled?

Go to Step 4

Go to Step 3

3

Enable the remote vehicle start by pressing the Set/Reset button until On is displayed.

Was the remote vehicle start option able to be enabled?

Go to Step 4

Go to Driver Information Center (DIC) Switch Inoperative

4

Observe the DIC for remote start related messages.

Is there any remote related message displayed?

Go to Indicator/Warning Message Description and Operation

Go to Step 5

5

Momentarily turn the ignition key to the start position.

Does the engine crank?

Go to Step 6

Go to Starter Solenoid Does Not Click

6

Does the engine start?

Go to Step 7

Go to Engine Cranks But Does Not Run for the 3.8L engine or Engine Cranks But Does Not Run for the 5.3L engine

7

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2