This test checks the validity of the module FLASH memory application values. Error detection is performed inside the control module. No external circuits are involved.
This diagnostic procedure supports the following DTC:
DTC B1014 Program Read Only Memory (ROM) Checksum Error
The module runs the program to detect a FLASH application error after each wake-up. The only requirements are battery positive voltage and ground.
The module retains a copy of the FLASH application checksum reference value in the FLASH memory. During wake-up the module shall compute the FLASH application value and compare it to the FLASH application checksum reference value. If the 2 values do not match the module sets this DTC.
The module will enter boot mode when this DTC sets. In boot mode, only the program FLASH memory function will be available.
• | A current DTC clears when the malfunction is no longer present. |
• | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
The following are most likely cause for this DTC being set:
• | Incorrect files downloaded to the module |
• | A module installed in the vehicle without the reprogramming procedure having been performed. |
Step | Action | Yes | No |
---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Does the DTC reset? | Go to Step 3 | Go to Diagnostic Aids |
3 | Replace the module setting the DTC as current. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 4 | -- |
4 |
Does the DTC reset? | Go to Step 2 | System OK |