The throttle actuator control (TAC) module contains data, which is essential for proper TAC system operation. The TAC module continuously checks the integrity of this data. If the TAC module detects a fault with electrically erasable programmable read only memory (EEPROM), or the TAC module detects a low voltage while the voltage on the powertrain control module (PCM) is not low, or the TAC module detects the vehicle ID from TAC module does not agree with the vehicle ID from the PCM, DTC P2107 sets.
This diagnostic procedure supports the following DTC:
DTC P2107 Throttle Actuator Control (TAC) Module Internal Circuit
• | DTCs P0606, P2108, and U0107 are not set. |
• | The ignition is in the crank or run position. |
If the TAC module detects low voltage, a fault with the EEPROM or vehicle ID recorded in the TAC module does not match the vehicle ID recorded in the PCM.
• | The control module stores the DTC information into memory when the diagnostic runs and fails. |
• | The malfunction indicator lamp (MIL) will not illuminate. |
• | The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records. |
• | The driver information center, if equipped, may display a message. |
• | A current DTC Last Test Failed clears when the diagnostic runs and passes. |
• | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
• | Clear the DTC with a scan tool. |
If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module Connector End Views and Engine Controls Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Is DTC P2119 also set? | Go to Step 3 | |
3 |
Did the DTC fail this ignition? | Go to Step 4 | Go to Diagnostic Aids |
4 | Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you complete the replacement? | Go to Step 5 | -- |
5 |
Did the DTC fail this ignition? | Go to Step 2 | Go to Step 6 |
6 |
Important: Be aware that repairing 1 individual condition may correct more than 1 DTC. Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | System OK |