VEHICLES AFFECTED: 1989-91 GEO METRO WITH 1.OL ENGINE
ENGINE (VIN) 6
1989-91 Geo Metro Models equipped with a 1.OL (VIN 6, RPO LP2) engine.
The chart included in this service bulletin has updated resistance specifications. When performing resistance measurements to the throttle position sensor, the chart in this service bulletin should be used. This chart replaces the chart shown in the following service publications:
* Figure C2-33. on page 6E2-C2-17 of the 1989 Geo Metro Service Manual (ST370-89)
* Figure C2-32 on page 6E2-C2-15 of the 1990 Geo Metro Service Manual (ST370-90)
* Figure C2-32 on page 6E2-C2-16 of the 1991 Geo Metro Service Manual Supplement (ST370-91S)
* Figure C2-32 on page 6E2-C2 of Dealer Service Update Bulletin 9O-2O2-6E (Corporate 016514) dated April, 1990
TERMINALS CONDITIONS RESISTANCE --------- ---------- ---------- WHEN THROTTLE LEVER-TO-STOP SCREW 0-5 KA BETWEEN CLEARANCE IS TERMINAL'A' 0.3 mm (0.01 2 in.) AND TERMINAL'B' WHEN THROTTLE (IDLE SWITCH) LEVER-TO-STOP SCREW INFINITE CLEARANCE IS 0.9 mm (0.035 in.)
BETWEEN TERMINAL'A' AND ------------- 4.37-8.13 K omega TERMINAL'B'
THROTTLE BETWEEN VALVE IS AT 240-1140 omega TERMINAL'A' IDLE POSITION AND TERMINAL'C' THROTTLE VALVE IS FULLY 3.17-6.6 K omega OPENED
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.