Tools Required

1. Slide the speedometer driven gear case boot up the speedometer cable.
2. Slide the speedometer driven gear case boot off the speedometer driven gear case.



3. Remove the following components from the speedometer driven gear case (2):

•	The speedometer cable retaining clip (7)

•	The speedometer cable

4. Remove the following components from the transaxle:

4.1.	The speedometer driven gear case retaining bolt (1)

4.2.	The speedometer driven gear case (2)

5. Use a standard drift punch in order to remove the speedometer driven gear case roll pin (6) from the speedometer driven gear case (2).
6. Remove the speedometer driven gear (5) from the speedometer driven gear case (2).
7. Remove the speedometer driven gear case O-ring (4) from the speedometer driven gear case (2).



8. Use the following tools in order to remove the speedometer driven gear case lip seal from inside of the speedometer driven gear case (1):

•	J 34839 Pinion Bearing Remover

•	J 37764 Slide Hammer Adapter

•	J 23907 Slide Hammer

9. Inspect the speedometer driven gear for excessive wear or damage.
10. Inspect the speedometer driven gear case O-ring for cuts or damage.

1. Apply J 36850 to the new speedometer driven gear lip seal.



2. Use the J 34857 in order to install the new speedometer driven gear lip seal (2) into the speedometer driven gear case (1).



3. Install the speedometer driven gear case O-ring (4) onto the speedometer driven gear case (2).
4. Apply J 36850 to the speedometer driven gear case O-ring (4).
5. Install the speedometer driven gear (5) into the speedometer driven gear case (2).
6. Use a standard drift punch in order to install the speedometer driven gear case roll pin (6) into the speedometer driven gear (5).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the speedometer driven gear case into the transaxle.

Use the speedometer driven gear case (1) retaining bolt in order to secure the speedometer driven gear case.

Tighten
Tighten the speedometer driven gear case retaining bolt (2) to 7 N·m (62 lb in).

8. Install the speedometer cable into the speedometer driven gear case.

Use the speedometer cable retaining clip in order to secure the speedometer cable.

9. Slide the speedometer driven gear case boot down the speedometer cable.
10. Slide the speedometer driven gear case boot over the speedometer driven gear case.