Caution: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

1. Loosen the fuel filler cap to relieve tank pressure.
2. Remove the center trim bezel from the center console by gently prying around the edges to disconnect the clips.
3. Remove the 4 screws and the radio from the center console, if equipped.
4. Disconnect the circuit opening relay electrical connector.
5. Crank the engine. Allow the engine to stall.
6. Crank the engine for an additional 3 seconds to ensure the relief of any remaining fuel pressure.
7. Disconnect the negative battery cable.
8. Connect the circuit opening relay electrical connector.
9. Install the center trim bezel to the center console. Push the bezel until the clips engage.
10. Tighten the fuel filler cap.