Tools Required

Important: Perform this test only at a normal operating fluid temperature of 50-80°C (122-176°F).

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove 6 bolts and left splash shield from vehicle.
3. Remove the left splash shield.



4. Remove the pressure tap bolt from the rear of the transaxle.
5. Install J 35752 into the line pressure tap at the rear of the transaxle.
6. Install J 21867 into J 35752 .
7. Lower the vehicle.
8. Route J 21867 hose over the front fender and through the driver's window so that it can be read from the passenger compartment.
9. Connect the scan tool to the Data Link Connector (DLC) and display the engine RPM.
10. Apply the parking brake and block the vehicle wheels.
11. Press the brake pedal fully and start the engine.
12. Display the engine speed (RPM) on the scan tool.

Caution: For the following four steps, procedures for testing line pressure at idle and stall speeds, the brake pedal must be fully pressed throughout the measurement procedure. Failure to do so could result in personal injury and/or property damage.

13. Place the manual selector in the drive (D) position and record the line pressure at idle speed (650-750 RPM). Do the same for the (D2) position.

Notice: DO NOT run engine at stall speed for more than five seconds continuously or engine oil and transaxle fluid temperatures may become excessively high.

14. Press the accelerator pedal fully (wide open throttle) and record the line pressure in the drive (D) position at stall speed (2,150-2,450 RPM). Release the accelerator pedal. Do the same for the (D2) position and record the line pressure.
15. Keeping the brake pedal fully pressed, place the selector lever in the reverse (R) position and record the line pressure at idle speed (650 to 750 RPM).
16. Press the accelerator pedal fully (wide open throttle) and record the line pressure in the reverse (R) position at stall speed (2,150-2,450 RPM). Release the accelerator pedal.
17. Keep the brake pedal fully pressed.
18. Place the manual selector in Low position. Record the line pressure at idle speed (650-750 RPM).
19. Press the accelerator pedal fully (wide open throttle) and record the line pressure in Low position at stall speed (2,150-2,450 RPM). Release the accelerator pedal.
20. Place the manual selector in Park position and turn the ignition switch to LOCK.
21. Remove the scan tool from the vehicle.
22. Remove J 21867 from the passenger compartment.
23. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
24. Remove J 21867 from J 35752 .
25. Remove J 35752 from the line pressure tap at the rear of the transaxle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

26. Install the line pressure tap bolt into the line pressure tap at the rear of the transaxle.

Tighten
Tighten the line pressure tap bolt to 9 N·m (80 lb in).

27. Install the left splash shield.
28. Secure with 6 bolts.

Tighten
Tighten the splash shield bolts to 5 N·m (44 lb in).

29. Lower the vehicle.

Evaluation

Compare the line pressure test results with the line pressure specifications. If the line pressure is not as specified, refer to the Line Pressure Test Diagnosis for further evaluation.