CORRECTED RADIO REMOVAL PROCEDURE 1988 SPRINT

Model and Year: 1987-88 SPRINT

The radio removal procedure shown on page 8-18 of the 1987 Sprint Service Manual (ST 370-87) is incorrect.

The following procedure should be used for radio removal in 1987 and 1988 Sprints.

Remove:

------ 1. Remove ash try and holder. 2. Remove radio mounting bracket nuts (2). 3. Remove heater control panel garnish. 4. Remove heater control knobs. 5. Remove heater control lever panel and A/C switch. 6. Remove heater control mounting screws. 7. Push heater controls forward into instrument panel. 8. Remove radio control knobs. 9. Through heater control opening, release top of radio front cover. 10. Through ash try opening, release top of radio front cover. 11. Remove radio front cover. 12. Release radio retainers located on both sides of the unit (See Illustration) and remove radio. 13. Disconnect antenna and electrical connectors.

Install:

-------

1. Install radio front cover to radio. 2. Install radio control knobs. 3. Connect antenna and electrical connectors. 4. Install radio into instrument panel. 5. Install heater control mounting screws. 6. Install heater control lever panel and A/C switch. 7. Install heater control knobs. 8. Install heater control panel garnish. 9. Install radio mounting bracket nuts (2) . 10. Install ash tray and holder.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.