Tools Required

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Remove the speedometer cable (3) from the speedometer drive gear case.
3. Remove the following items from the extension case:

•	One bolt (2).

•	The ground wire (1).

•	The speedometer driven gear case.




4. Remove the following items from the speedometer driven gear case:

•	One roll pin.

•	The speedometer driven gear case (1).




5. Remove the speedometer driven gear lip seal (1) from the speedometer driven gear case (2).
6. Inspect the speedometer driven gear for excessive wear or damage. Replace the speedometer driven gear if necessary.

1. Apply the J 36850 to the new speedometer driven gear lip seal.



2. Install the new speedometer driven gear lip seal into the speedometer driven gear case (2) using the J 34833 .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the speedometer driven gear (1) into the speedometer gear case (2). Secure the speedometer driven gear with one roll pin.



4. Install the speedometer driven gear case and the ground wire (1) to the extension case (4); secure with one bolt (2).

Tighten
Tighten the speedometer driven gear case retaining bolt to 12 N·m (106 lb in).

5. Install the speedometer cable to the speedometer driven gear case.
6. Lower the vehicle.