Removal Procedure
Important: Take care when handling the mass air flow/intake air temperature (MAF/IAT) sensor.
Do not dent, puncture, or otherwise damage the honeycell located at the air inlet
end of the MAF/IAT. Do not touch the sensing elements or allow anything including
cleaning solvents and lubricants to come in contact with them. Use a small amount
of a non-silicone based lubricant, on the air duct only, to aid in installation.
Do not drop or roughly handle the MAF/IAT sensor.
- Remove air intake resonator. Refer to
Air Cleaner Resonator Outlet Duct Replacement
.
- Disconnect the MAF/IAT sensor electrical connector.
- Loosen the clamp securing the MAF/IAT sensor to the air cleaner housing.
- Remove the MAF/IAT sensor from the air cleaner assembly.
Installation Procedure
Important:: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction.
The arrow must point toward the engine.
- Locate
the air flow direction arrow (2) on the MAF/IAT sensor.
- Install the MAF/IAT sensor on to the air cleaner housing.
- Tighten the clamp securing the MAF/IAT sensor to the air cleaner housing.
- Connect the MAF/IAT electrical connector.
- Install air intake resonator. Refer to
Air Cleaner Resonator Outlet Duct Replacement
.