GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2003 🢒 H2 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Rear License Plate Lamp Replacement

Removal Procedure

    Object Number: 813577 Size: SH
  1. Remove the screws from the license pocket bezel.
  2. Remove the bezel and the lamp.
  3. Disconnect the electrical connector.
  4. Remove the screw from the lamp.
  5. Remove the lamp from the vehicle.
  6. Remove the bulb socket from the lamp.
  7. Remove the bulb.

Installation Procedure

    Object Number: 813577 Size: SH
  1. Install the bulb to the socket.
  2. Install the bulb socket to the lamp.
  3. Install the lamp to the vehicle.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the screws to the lamp.

    5. Tighten
    Tighten the screws to 3 N·m (26 lb in).

  5. Connect the electrical connector.
  6. Install the bezel and lamp to the license plate pocket.
  7. Install the screws to the license pocket bezel.

    8. Tighten
    Tighten the screws to 3 N·m (26 lb in).