Tail/Turn Signal Lamp Replacement SUV

1. Remove the screws from the lamp.
2. Remove the lamp from the body.
3. Disconnect the electrical harness at the connector.
4. Turn the bulb socket counterclockwise.
5. Remove the bulb from the socket.

1. Install the bulb to the socket.
2. Turn the bulb socket clockwise in order to lock.
3. Connect the electrical harness at the connector.
4. Install the lamp to the body.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the screws to the lamp.

Tighten
Tighten the screws to 6 N·m (53 lb in).