GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2003 🢒 H2 🢒 Body and Accessories 🢒 Interior Trim 🢒 Body Side Trim Panel Replacement - Right Side

Removal Procedure

    Object Number: 833504 Size: SH
  1. Remove the rear pillar trim panel.
  2. Remove the inflator nozzle retaining nut.
  3. Remove the inflator bezel.
  4. Remove the inflator switch from the bezel.
  5. Using a suitable flat bladed tool, press downward on the door lock switch and rotate the top of the switch outward to disengage the switch from the trim panel.
  6. Remove the connector position assurance (CPA) pin and remove the electrical connector from the switch.

    7. Object Number: 833506 Size: SH
  7. Remove the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  8. Remove the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  9. Firmly grasp and gently pull up on the body side panel tray to disengage it from the body panel.
  10. Disconnect the 12 volt power supply electrical connector.
  11. Remove the inflator nozzle from the panel.

    12. Object Number: 833490 Size: SH
  12. Firmly gasp and gently pull the front edge of the body panel to disengage the retaining clips.
  13. Remove the right side body panel from the vehicle.
  14. Inspect and replace any missing or broken retaining clips.

Installation Procedure

    Object Number: 833490 Size: SH
  1. Install the body panel to the vehicle.
  2. Align the retaining clips with he openings in the body and gently press to fully seat the clips.

    3. Object Number: 833506 Size: SH
  3. Connect the 12 volt power supply connector.
  4. Install the inflator nozzle into the body panel opening.
  5. Install the body side panel tray.
  6. Install the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  7. Install the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .

    8. Object Number: 833504 Size: SH
  8. Connect the electrical connector to the door lock switch and install the CPA.
  9. Install the door lock switch into the body panel.
  10. Install the inflator switch to the inflator bezel.
  11. Install the inflator bezel to the body panel.
  12. Install the inflator nozzle retaining nut.
  13. Install the rear pillar trim panel.