GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2003 🢒 H2 🢒 Body and Accessories 🢒 Body Rear End 🢒 Liftgate Lock Striker Replacement

Removal Procedure
  1. Open the liftgate.
  2. Remove the liftgate door sill plate. Refer to Liftgate Door Sill Plate Replacement .
  3. Mark the location of the striker with a grease pencil.

    4. Object Number: 870174 Size: SH
  4. Remove fasteners from the striker (1).

    5. Important: Using a grease pencil, mark the strikers location prior to removal.

  5. Remove the striker and shims, if equipped, from the vehicle.

Installation Procedure

    Object Number: 870174 Size: SH
  1. Position the striker, to the location marks.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the fasteners (1) to the striker.

    3. Tighten
    Tighten fasteners to 25 N·m (18 lb ft).

  3. Install the liftgate door sill plate. Refer to Liftgate Door Sill Plate Replacement .