Rear Axle Shaft Seal and/or Bearing Replacement. HUMMER H2 2003

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2003 🢒 H2 🢒 General Information 🢒 Vibration Diagnosis and Correction 🢒 Rear Axle Shaft Seal and/or Bearing Replacement

•	J 8092 Driver Handle

•	J 2619-01 Slide Hammer

•	J 29709 Wheel Bearing Installer (9.5 inch Axle)

•	J 29713 Axle Seal Installer (9.5 inch Axle)

•	J 44685 Rear Axle Seal and Bearing Remover

Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Drain the rear axle lubricant. Refer to Rear Axle Lubricant Replacement .
Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
Remove the axle shaft seal and the bearing from the axle housing using the J 2619-01 and the J 44685 .

Install the axle shaft bearing using the J 29709 and the J 8092 .
Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.

Install the axle shaft seal using the J 29713 .
Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
Install the axle shaft. Refer to Rear Axle Shaft Replacement .
Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Fill the rear axle with lubricant. Refer to Rear Axle Lubricant Replacement .
Lower the vehicle.