GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2004 🢒 H2 🢒 Suspension 🢒 Front Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .

    3. Object Number: 793300 Size: SH
  3. Remove the insulator clamp bolts.
  4. Remove the clamps.
  5. Remove the insulators.
  6. Inspect all of the parts for wear and damage.

Installation Procedure

    Object Number: 793301 Size: SH
  1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.

    2. Object Number: 793300 Size: SH
  2. Install the insulators to the stabilizer shaft .
  3. Install the stabilizer shaft .
  4. Install the clamps over the insulators and the stabilizer shaft.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install insulator clamp bolts.

    6. Tighten
    Tighten the bolts to 50 N·m (37 lb ft).

  6. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  7. Lower the vehicle.