GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2005 🢒 H2 🢒 Engine 🢒 Engine Cooling 🢒 Radiator Surge Tank Replacement

Removal Procedure

    Object Number: 801110 Size: SH
  1. Drain the cooling system. Refer to Cooling System Draining and Filling .
  2. Reposition the surge tank inlet hose clamp (1) from the surge tank (2).
  3. Remove the surge tank inlet hose (6) from the surge tank (2).
  4. Reposition the surge tank outlet hose clamp (5) from the surge tank (2).
  5. Remove the surge tank outlet hose (3) from the surge tank (2).

    6. Object Number: 801109 Size: SH
  6. Remove the bolt (1) from the surge tank (4).
  7. Remove the nut (3) from the surge tank (4).
  8. If equipped disconnect the electrical connector from the low coolant level switch.
  9. Remove the surge tank (4) from the vehicle (5).

Installation Procedure

    Object Number: 801109 Size: SH
  1. Install the surge tank (4) to the vehicle (5).
  2. If equipped connect the electrical connector to the low coolant level switch.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the bolt (1) to the surge tank (4).

    4. Tighten
    Tighten the bolt to 9 N·m (80 lb in).

  4. Install the nut (3) to the surge tank (4).

    5. Tighten
    Tighten the nut to 9 N·m (80 lb in).


    Object Number: 801110 Size: SH
  5. Install the surge tank outlet hose (3) to the surge tank (2).
  6. Position the surge tank outlet hose clamp (5) to the surge tank (2).
  7. Install the surge tank inlet hose (6) to the surge tank (2).
  8. Position the surge tank inlet hose clamp (1) to the surge tank (2).
  9. Fill the cooling system. Refer to Cooling System Draining and Filling .