Low Engine Oil Level Indicator Always On. HUMMER H2 2005

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2005 🢒 H2 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Low Engine Oil Level Indicator Always On

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Install a scan tool. Turn the ignition ON, with the engine OFF. With the scan tool, observe the Engine Oil Level Switch parameter in the PCM Engine Data 2 data list. Does the Engine Oil Level Switch parameter display OK?	Go to Step 3	Go to Step 4
3	Does the CHECK ENG OIL LEVEL indicator remain illuminated after the displays test?	Go to Step 11	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
4	Turn the ignition OFF. Disconnect the engine oil level switch. Connect a 3-amp fused jumper between the signal circuit of the engine oil level switch and a good ground. Turn the ignition ON, with the engine OFF. With the scan tool, observe the Engine Oil Level Switch parameter. Does the Engine Oil Level Switch parameter display OK?	Go to Step 6	Go to Step 5
5	Test the signal circuit of the engine oil level switch for a short to battery voltage, for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 12	Go to Step 8
6	Test the ground circuit of the engine oil level switch for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 12	Go to Step 7
7	Inspect for poor connections at the harness connector of the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 12	Go to Step 9
8	Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 12	Go to Step 10
9	Replace the engine oil level switch. Refer to Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical. Did you complete the replacement?	Go to Step 12	--
10	Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 12	--
11	Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 12	--
12	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2