Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Interior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Turn ON the vanity mirror lamp. Does the system operate normally? | Go to Testing for Electrical Intermittents in Wiring Systems | Go to Step 3 |
3 | Are all of the reading, visor and I/P compartment lamps inoperative? | Go to Step 4 | Go to Step 6 |
4 | Is the TBC 2C Fuse in the I/P fuse block open? | Go to Step 5 | Go to Step 6 |
5 | Test the battery positive voltage circuit of the body control module (BCM) for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 9 |
6 | Test the inadvertent power supply voltage circuit of the vanity lamp for a short to ground, high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 7 |
7 | Test the ground circuit of the vanity lamp for high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
8 | Inspect the inoperative bulb for an open filament. Is the bulb OK? | Go to Step 11 | Go to Step 10 |
9 | Repair the inadvertent power supply voltage circuit for a short to ground. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 12 | -- |
10 | Replace the inoperative bulb. Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the sunshade. Refer to Sunshade Replacement in Interior Trim. Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
