Clearance Lamp Replacement SUV

1. Remove the screw from the lamp.



2. Remove the lamp by tilting back the assembly and disengaging the hook.
3. Remove the bulb socket.
4. Remove the lamp from the vehicle.
5. Remove the bulb.

1. Install the bulb.



2. Install the lamp to the vehicle.
3. Install the bulb socket.
4. Install the lamp assembly by engaging the hook and tilting the assembly down into place.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the screw to the lamp assembly.

Tighten
Tighten the screw to 2.5 N·m (22 lb in).

Clearance Lamp Replacement SUT Front

1. Remove the screw from the lamp.
2. Remove the lamp by lifting upward at the rear edge.
3. Disconnect the lamp socket.
4. Remove the lamp housing from the vehicle.
5. Remove the bulb, if necessary.

1. Install the bulb to the socket.
2. Install the lamp housing to the vehicle. The front edge must be secure.
3. Ensure the lamp housing foam seal is not damaged.
4. Install the lamp assembly to the roof luggage carrier side rail end cap.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the screw to the lamp assembly.

Tighten
Tighten the screw to 2.5 N·m (22 lb in).

Clearance Lamp Replacement SUT Rear

1. Remove the screw from the lamp.
2. Remove the lamp by lifting upward.
3. Disconnect the lamp socket.
4. Remove the lamp housing from the vehicle.
5. Remove the bulb, if needed.

1. Install the bulb to the socket.
2. Install the socket to the lamp housing.
3. Ensure the lamp housing foam seal is not damaged.
4. Install the lamp assembly to the roof luggage carrier side rail end cap.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the screw to the lamp assembly.

Tighten
Tighten the screw to 2.5 N·m (22 lb in).