Tail/Turn Signal Lamp Replacement SUV

1. Remove the screws from the lamp.
2. Remove the lamp from the body.
3. Disconnect the electrical harness at the connector.
4. Turn the bulb socket counterclockwise.
5. Remove the bulb from the socket.

1. Install the bulb to the socket.
2. Turn the bulb socket clockwise in order to lock.
3. Connect the electrical harness at the connector.
4. Install the lamp to the body.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the screws to the lamp.

Tighten
Tighten the screws to 6 N·m (53 lb in).

Tail/Turn Signal Lamp Replacement SUT

1. Open the spare tire carrier.
2. Open the endgate.



3. Release either the right or left side endgate cable from the body side bolt in order to remove the lamp.
4. Remove the screws (2) from the lamp (1).
5. Remove the inboard side of the lamp from the endgate opening.
6. Pull the lamp housing outward.
7. Disconnect the electrical harness at the main body harness connector.



8. Turn the bulb socket (3) counterclockwise one at a time from the lamp (1).
9. Remove the bulbs from the sockets, if needed.

1. Install the bulbs into the sockets (3).
2. Position each socket into the lamp (1) and rotate 1/8 turn in order to secure.



3. Position the lamp housing (1) to the rear body opening.

Important: The outboard edge of the lamp housing will need to be positioned first.

4. Connect the lamp housing electrical connector to the main body wire harness connector.
5. Ensure all electrical wiring is positioned away from the sharp sheet metal flanges.
6. Secure the inboard side of the lamp (1) to the endgate opening.

Notice: Refer to Fastener Notice in the Preface section.

7. Install the screws (2).

Tighten
Tighten the screws to 6 N·m (53 lb in).




8. Re-secure either the right or left side endgate cable to the body side bolt after lamp installation.
9. Close the endgate.
10. Latch and secure the spare tire carrier.