Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Connector End View Reference: Lighting Systems Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Place the headlamp switch in the ON position.
2. Place the dimmer switch in the high beam position.

Do the high beam headlamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Is only one high beam headlamp inoperative?

Go to Step 4

Go to Step 5

Test the high beam headlamp supply voltage circuit for high resistance, an open or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 8

1. Disconnect the headlamp high relay. Refer to Relay Replacement in Wiring Systems.
2. Connect a test lamp between the control circuit of the headlamp high relay and the battery positive voltage circuit of the headlamp high relay connector.

Does the test lamp illuminate?

Go to Step 13

Go to Step 6

1. Connect the headlamp high relay.
2. Test the headlamp dimmer switch signal and ground circuits for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct a condition?

Go to Step 15

Go to Step 7

1. Place the headlamp switch in the ON position.
2. Connect a fused jumper from ground to the headlamp dimmer switch signal terminal of the headlamp dimmer switch connector.

Do the high beam headlamps illuminate?

Go to Step 9

Go to Step 10

Inspect for poor connections at the harness connector of the inoperative bulb. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 11

Inspect for poor connections at the harness connector of the headlamp dimmer switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 14

Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 12

Replace the high beam bulb. Refer to Headlamp Replacement or Headlamp Bulb Replacement .

Did you complete the replacement?

Go to Step 15

--

Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 15

--

Replace the high beam headlamp relay. Refer to Relay Replacement in Wiring Systems.

Did you complete the replacement?

Go to Step 15

--

Replace the headlamp dimmer switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column.

Did you complete the repair?

Go to Step 15

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3