Removal Procedure
- Remove the fuel sender. Refer to
Fuel Sender Assembly Replacement
.
- Place the fuel sender on a clean work surface.
- Disconnect the fuel level sensor electrical connector (1)
from the module connector.
- Remove the fuel level sensor retaining clip.
- Squeeze the retaining tabs together in order to slide the fuel lever sensor
off of the reservoir.
Installation Procedure
- Slide the fuel lever sensor (3) onto the reservoir
until the retaining tabs snap into place.
- Connect the fuel level sensor electrical connector (1)
to the module connector.
- Install the fuel sender. Refer to
Fuel Sender Assembly Replacement
.