Tools Required
| • | J 34725 End Play Checking
Adapter |
| • | J 43205 End Play
Fixture Adapter (300 mm) |
Important: Torque converter size is model dependent.
- Install an end play fixture adapter.
| • | Use J 25022
for a
245 mm and 258 mm turbine shaft (1). |
| • | Use J 34725
for a
298 mm turbine shaft (2). |
| • | Use J 43205
for
a 300 mm turbine shaft (3). |
- Install the J 24773-A
.
- Remove an oil pump bolt.
- Install J 25025-7A
(or
a 278 mm or 11 in bolt) and lock nut.
- Install J 8001
.
- Set the J 8001
to zero.
- Pull up on J 24773-A
.
Proper end play should be 0.13-0.92 mm (0.005-0.036 in).
- The selective washer (616), which controls the end play, is located between
the input housing (621) and the thrust bearing (615) on the oil pump hub.
If the end play measurement is incorrect, refer to the
End Play Specifications
table. Choose a new selective washer (616) based
on the original selective washer and the information contained in the table.
If the dial indicator shows no end play, the selective washer (616) and thrust
bearing (615) may have been misassembled.
- Correct the end play by changing the selective washer (616).
Tools Required
| • | J 34725 End Play Checking Adapter |
| • | J 43205 End Play Fixture Adapter
(300 mm) |
Important: Torque converter size is model dependent.
- Install an end play fixture adapter.
| • | Use J 25022
for a 245 mm
and 258 mm turbine shaft (1). |
| • | Use J 34725
for a 298 mm
turbine shaft (2). |
| • | Use J 43205
for a 300 mm
turbine shaft (3). |
- Install the J 24773-A
.
- Remove an oil pump bolt.
- Install J 25025-7A
(or a 278 mm
or 11 in bolt) and lock nut.
- Install J 8001
.
- Set the J 8001
to zero.
- Pull up on J 24773-A
.
Proper end play should be 0.13-0.92 mm (0.005-0.036 in).
- The selective washer (616), which controls the end play, is located between
the input housing (621) and the thrust bearing (615) on the oil pump hub.
If the end play measurement is incorrect, refer to the
End Play Specifications
table. Choose a new selective washer (616) based on the original selective washer
and the information contained in the table.
If the dial indicator shows no end play, the selective washer (616) and thrust
bearing (615) may have been misassembled.
- Correct the end play by changing the selective washer (616).
