SMU - Revised Endgate Adjustment Procedure

This bulletin is being issued to revise Step 2 of the Endgate Adjustment procedure in the Body Rear End sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

The English specification has been revised in Step 2 as follows:

2. Adjust the liftgate (1) to the rear bumper fascia (2) gap (A) to 22-24 mm (0.86 in-0.94 in).