GM Service Manual Online
For 1990-2009 cars only

The following service procedures require either a programming or a setup event preformed for a complete repair.

PCM Replacement

If the powertrain control module (PCM) is replaced, the following procedures must be performed:

  1. The PCM programming--Refer to Service Programming System (SPS) .
  2. The CKP variation learn--Refer to Crankshaft Position System Variation Learn .
  3. The Immobilizer programming--Refer to Programming Theft Deterrent System Components .

PCM Reprogramming

    • If the PCM needs to be reprogrammed, refer to Service Programming System (SPS) .
    • Engine Oil Life Remaining--When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
    • Transmission Fluid Life Remaining--When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, a CKP Variation Learn Procedure must be performed. Refer to Crankshaft Position System Variation Learn .

    • Engine replacement
    • Any engine repair that disturbs the crankshaft position (CKP) sensor or its relationship with the crankshaft reluctor wheel
    • CKP sensor