GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2007 🢒 H2 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the rear axle at curb height.

    3. Object Number: 793283 Size: SH
  3. Remove the stabilizer shaft link bolt and nut from the frame bracket.

    4. Object Number: 793284 Size: SH
  4. Remove the stabilizer shaft insulator bracket mounting bolts.
  5. Remove the stabilizer shaft.
  6. Remove the stabilizer shaft insulators brackets.
  7. Remove the stabilizer shaft insulators.

Installation Procedure

    Object Number: 793284 Size: SH
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft insulator brackets to the rear axle.
  4. Install the stabilizer shaft bracket mounting bolts.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 613612 Size: SH

    Important: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.

  5. Install the stabilizer shaft link nut to the ball stud.

    6. Tighten

    1. Tighten the ball stud to stabilizer shaft nut to 80 N·m (59 lb ft).
    2. Tighten the insulator bracket bolts to 33 N·m (24 lb ft).
  6. Remove the rear axle support.
  7. Lower the vehicle.