Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Open the hood.
- Remove the window wiper arms. Refer to
Windshield Wiper Arm Replacement.
- Remove the window side reveal moldings from the vehicle. Refer to
Windshield Side Reveal Molding Replacement .
- Remove the cowl air inlet grille panel. Refer to
Non-Functional Air Inlet Grille Panel Replacement.
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
- Cover to protect the following parts from broken glass:
| • | The defroster outlets and A/C outlets |
| • | The seats and carpeting |
- Remove the rear view mirror. Refer to
Inside Rearview Mirror Replacement .
Important: The window lower supports (1) have molded in locks with an urethane adhesive strip (2) on the back side. Once the window lower stop have been removed they must be replaced.
- If necessary, remove the window lower supports (1) by using a flat bladed tool, lightly prying upward in the middle until it releases.
Important: Keep the cutting edge of the tool against the window.
- This will allow the urethane adhesive to be separated from the window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
- Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool. Keep the cutting edge of the utility knife against the glass.
- With the aid of an assistant remove the window from the vehicle.
