Important: The ignition switch must be in the OFF position when removing the instrument panel (I/P) cluster.

1. Remove the I/P cluster trim plate from the instrument panel. Refer to Instrument Cluster Trim Panel Replacement .
2. Remove the screws from the I/P cluster to instrument panel.



3. Remove the I/P cluster from the instrument panel.



4. Disconnect the I/P cluster electrical connections.

1. Connect the electrical connections to the cluster.
2. Position the I/P cluster to the instrument panel.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the screws to the instrument panel cluster.

Tighten
Tighten the screws to 2 N·m (18 lb in).




4. Install the instrument cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .

When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Instrument Cluster Programming and Setup .