Important: Perform the Crankshaft Position System Variation Learn when the crankshaft position sensor is removed or replaced.

Caution: Refer to Battery Disconnect Caution in the Preface section.

1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the starter. Refer to Starter Motor Replacement .



4. Disconnect the crankshaft position (CKP) sensor electrical connector.



5. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
6. Remove the CKP sensor retaining bolt.
7. Remove the CKP sensor.

Notice: Refer to Fastener Notice in the Preface section.

1. Install the CKP sensor.



2. Install the CKP sensor retaining fastener.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




3. Connect the CKP sensor electrical connector.



4. Install the starter. Refer to Starter Motor Replacement .
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .