Fuel Pump Flow Control Module Replacement. HUMMER H2 2008

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2008 🢒 H2 🢒 Engine 🢒 Engine Controls and Fuel - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L 🢒 Fuel Pump Flow Control Module Replacement

Callout	Component Name
Preliminary Procedure Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Fuel Pump Flow Control Module Bolt (Qty: 3) Notice: Refer to Fastener Notice in the Preface section. Tip The bolts used are two headed and can be loosened from the module side, then maneuvered out of the slots. Tighten 9 N·m (80 lb in)
2	Fuel Pump Flow Control Module Procedure Disconnect the electrical connector. If replacing the fuel pump flow control module, program the control module. Refer to Control Module References .

Callout

Component Name

Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fuel Pump Flow Control Module Bolt (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tip
The bolts used are two headed and can be loosened from the module side, then maneuvered out of the slots.

Tighten
9 N·m (80 lb in)

Fuel Pump Flow Control Module

Disconnect the electrical connector.
If replacing the fuel pump flow control module, program the control module. Refer to Control Module References .