Special Tools

1. Remove the oil pump. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement .
2. Rotate the crankshaft until the timing marks on the crankshaft and the camshaft sprockets are aligned.

Notice: Do not turn the crankshaft assembly after the timing chain has been removed in order to prevent damage to the piston assemblies or the valves.

3. Remove the camshaft sprocket bolts.
4. Remove the camshaft sprocket and timing chain.



5. Use the J 8433 , the J 41816-2 and the J 41558 in order to remove the crankshaft sprocket.



6. Remove the crankshaft sprocket.



7. Remove the crankshaft sprocket key, if required.
8. Clean and inspect the timing chain and sprockets. Refer to Camshaft Position Actuator Cleaning and Inspection .

1. Install the key into the crankshaft keyway, if previously removed.



2. Tap the key (1) into the keyway until both ends of the key bottom onto the crankshaft.



3. Install the crankshaft sprocket onto the front of the crankshaft. Align the crankshaft key with the crankshaft sprocket keyway.



4. Use the J 41665 in order to install the crankshaft sprocket.

Install the sprocket onto the crankshaft until fully seated against the crankshaft flange.

5. Rotate the crankshaft sprocket until the alignment mark is in the 12 o'clock position.




Important: 

•	Properly locate the camshaft sprocket locating pin with the camshaft sprocket alignment hole.

•	The sprocket teeth and timing chain must mesh.

•	The camshaft and the crankshaft sprocket alignment marks MUST be aligned properly.

Locate the camshaft sprocket alignment mark in the 6 o'clock position.

6. Install the camshaft sprocket and timing chain.

Notice: Refer to Fastener Notice in the Preface section.




7. If necessary, rotate the camshaft or crankshaft sprockets in order to align the timing marks.
8. Install the camshaft sprocket bolts.

Tighten
Tighten the camshaft sprocket bolts to 35 N·m (26 lb ft).

9. Install the oil pump. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement .