Preliminary Procedure

Caution: Refer to SIR Caution in the Preface section.

Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

1. Disable the SIR system. Refer to SIR Disabling and Enabling .
2. Remove the rear side door trim panel . Refer to Rear Side Door Trim Panel Replacement .
3. Remove the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement .

1

Side Impact Inflatable Restraint Sensor - Rear

Notice: Refer to Fastener Notice in the Preface section.

Procedure

1. Disconnect the electrical connector.
2. Loosen the side impact inflatable restraint sensor bolts. (Qty: 2)
3. Remove the side impact inflatable restraint sensor from the vehicle.

Tip
The bolts and the push in fasteners are an integral part of the sensor and should remain with the sensor.

Tighten
8 N·m (71 lb in)