Parking and Turn Signal Lamp Replacement SUV

1. Remove the grille. Refer to Grille Replacement .



2. Open the hood.
3. Remove the retaining nuts.
4. Disconnect the electrical harness connector (2).
5. Disengage the retaining clips.
6. Close the hood.
7. Remove the lamp.
8. Remove the bulb socket by turning the socket counterclockwise.
9. Remove the bulb.

1. Install the bulb.



2. Install the bulb socket (6) by turning the socket clockwise.
3. Install the lamp.
4. Open the hood.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the retaining nuts (2).

Tighten
Tighten the nuts to 6 N·m (53 lb in).

6. Connect the electrical harness.
7. Close the hood.
8. Install the grille. Refer to Grille Replacement .

Parking and Turn Signal Lamp Replacement SUT Rear

1. Release the lamp socket (1) from the lens.
2. From the exterior side of the end cap, insert a flat blade at the top side center of the lens.
3. Gently pry upward on the flat blade in order to release the clip (2).
4. Pull the top of the lens outward.
5. Lift the lens from the opening.

Important: Ensure the bottom edge is secured first.

1. Position the lamp housing to the end cap opening.
2. Press inward at the top of the lamp in order to secure the tab (3).



3. Position the lamp socket (1) into the lamp (2) and turn 1/4 in order to secure.