GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2008 🢒 H2 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Windshield Washer Solvent Level Switch Replacement

Removal Procedure

    Object Number: 1453811 Size: SH
  1. Open the hood.
  2. Remove the washer solvent from the washer solvent container.
  3. Disconnect the washer solvent level sensor (6) electrical connector.
  4. Remove the A/C low pressure switch. Refer to Air Conditioning Cycling Switch Replacement .
  5. Mark the location of the sensor prior to removal.

    6. Object Number: 869051 Size: SH

    Important: The level sensor arm hinges at the point called out (1). Before servicing the level sensor, it is necessary to get the level sensor arm in a horizontal position. Failure to do so will result in breakage of the level sensor.

  6. Get the level sensor in a horizontal position by inserting a long, narrow tool through the washer solvent fill hole, and gently raising the sensor arm.

    7. Object Number: 869068 Size: SH
  7. Remove the level sensor from the washer solvent container.

Installation Procedure

    Object Number: 869051 Size: SH
  1. Get the level sensor in a horizontal position as shown (1).

    2. Object Number: 1453811 Size: SH
  2. Install the level sensor (6) in the washer solvent container (5). Ensure to reference the locating mark made during removal.
  3. Connect the washer solvent electrical connector.
  4. Install the A/C low pressure switch. Refer to Air Conditioning Cycling Switch Replacement .
  5. Refill the washer solvent container.
  6. Inspect for leaks.
  7. Close the hood.