GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2008 🢒 H2 🢒 Body Systems 🢒 Lighting 🢒 Tail Lamp Guard Replacement

Removal Procedure

    Object Number: 855707 Size: SH
  1. Open the liftgate.

    2. Object Number: 855709 Size: SH
  2. Remove the screws retaining the tail lamp guard.

    3. Object Number: 855708 Size: SH
  3. Carefully seperate adhesive strip from body.
  4. Remove the tail lamp guard from the vehicle.

Installation Procedure

    Object Number: 855708 Size: SH
  1. Position the tail lamp guard to the vehicle.

    2. Object Number: 855707 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the screws retaining the tail lamp guard.

    3. Tighten
    Tighten to 6 N·m (53 lb in).

  3. Clean the surface where the adhesive strip will mount with varnish and makers (VMP) naptha.

    4. Object Number: 855709 Size: SH
  4. Carefully align adhesive strip to body and pull exposed tape lead down.
  5. Apply approximately 30 psi to tail lamp guard to adhere guard to the body.
  6. Close the liftgate.