Windshield Side Reveal Molding Replacement Side

1. Remove the air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel Replacement .
2. Remove the retaining screws.
3. Apply outward pressure at the bottom of the windshield pillar reveal molding to release the adhesive strip.
4. Pull the molding down to disengage the windshield pillar reveal molding from the roof rack.
5. Remove the side reveal molding from the pillar

1. Install the windshield pillar side reveal molding to the vehicle.
2. Push the molding up to engage the windshield pillar reveal molding into the roof rack.
3. Apply inward pressure at the bottom of the windshield pillar reveal molding to wet out the adhesive strip.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the retaining screws.

Tighten
Tighten the screws to 3 N·m (26 lb in).

5. Install the air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel Replacement .