Important: When replacing the evaporative emission (EVAP) pipe, always replace the pipe with original equipment or parts that meet the GM specifications for this part. The replacement pipe must have the same type of fittings as the original pipe in order to ensure the integrity of the connection.

1. Clean all the EVAP pipe connections and the surrounding areas before disconnecting the pipes in order to avoid possible contamination of the EVAP system.
2. Disconnect the engine compartment EVAP pipe (6) from the chassis EVAP pipe (3).
3. Cap the engine compartment EVAP pipe.
4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Remove the left hand catalytic converter. Refer to Catalytic Converter Replacement .
6. Remove the EVAP pipe from the bellhousing stud clip (4).
7. Remove the EVAP pipe from the transmission bracket clip.



8. Disconnect the rear EVAP purge pipe from the EVAP canister.
9. Cap the rear EVAP purge pipe.
10. Note the position of the EVAP pipe for aid in installation.
11. Remove the EVAP pipe from the retaining clips.
12. Remove the EVAP pipe.

1. Install the EVAP pipe into the retaining clips.



2. Remove the cap from the rear EVAP pipe.
3. Connect the rear EVAP purge pipe to the EVAP canister.



4. Install the EVAP pipe into the transmission bracket clip.
5. Install the EVAP pipe into the bellhousing stud clip (4).
6. Install the left hand catalytic converter. Refer to Catalytic Converter Replacement .
7. Lower the vehicle.
8. Remove the cap from the engine compartment EVAP pipe.
9. Connect the engine compartment EVAP pipe (6) to the chassis EVAP pipe (3).