Quarter Window Replacement SUV Body Side Quarter Window

Special Tools

Warning: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

1. Apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim, to help prevent damage.

Warning: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

2. Cover to protect the following parts from broken glass as necessary:

The seats and carpeting

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.





Note: Keep the cutting edge of the tool against the quarter window.

3. This will allow the urethane adhesive to be separated from the quarter window.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

•	Use J 24402-A , J 39032 or equivalent in order to remove the quarter window.

4. If the locator pins were damaged during removal, they must be replaced.
5. With the aid of an assistant, use the suction cups to remove the window from the opening.

1. Install the quarter window into the opening. Refer to Adhesive Installation of Stationary Windows.



2. Insure the pinchweld is primed properly.
3. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Quarter Window Replacement SUT Body Side Window

Special Tools

Warning: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

1. Apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim, to help prevent damage.

Warning: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

2. Cover to protect the following parts from broken glass as necessary:

The seats and carpeting

3. Remove the rear sail panel molding. Refer to Sail Panel Molding Replacement.
4. Remove the roof header garnish molding. Refer to Roof Rear Header Garnish Molding Replacement.
5. Remove the rear lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement - Upper.
6. Open the midgate.
7. Release either the top left or right side midgate window weatherstrip prior to cutting the urethane adhesive bead.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.





Note: Keep the cutting edge of the tool against the quarter window.

8. This will allow the urethane adhesive to be separated from the quarter window.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

•	Use J 24402-A , J 39032 or equivalent in order to remove the quarter window.

9. If the locator pins were damaged during removal, they must be replaced.
10. With the aid of an assistant, use the suction cups to remove the window from the opening.

1. Install the quarter window into the opening. Refer to Adhesive Installation of Encapsulated Stationary Windows.



2. Ensure the pinchweld is primed properly.
3. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
4. Reposition the midgate window weatherstrip to the pinchweld flange.
5. Install the rear lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement - Upper.
6. Close the midgate.
7. Install the rear header garnish molding. Refer to Roof Rear Header Garnish Molding Replacement.
8. Install the rear sail panel molding. Refer to Sail Panel Molding Replacement.