Diagnostic Instructions
DTC Descriptors
DTC C0136 00: Base Brake System Pressure Circuit
DTC C0136 0A: Base Brake System Pressure Circuit Rate of Change Above Threshold
DTC C0136 5A: Base Brake System Pressure Circuit Plausibility Failure
Circuit/System Description
The electronic brake control module (EBCM) monitors an internal input from the master cylinder pressure sensor to enhance Antilock Brake System (ABS) braking and vehicle stability if equipped.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
| • | When vehicle speed is more than 7 km/h (4 mph), the master cylinder pressure does not change for 30 seconds with the brake applied. |
| • | When vehicle speed is more than 10 km/h (6 mph), the master cylinder pressure signal is erratic. |
| • | Master cylinder pressure signal is out of range. |
| • | Master cylinder pressure is high for 5 seconds with the stop lamp switch signal OFF. |
Action Taken When the DTC Sets
| • | The EBCM disables traction control system (TCS) and vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
| • | A DIC message and/or a warning message may be displayed. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present and the DTC is cleared with a scan tool. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The master cylinder pressure sensor is located internally in the BPMV and is not serviceable.
Reference Information
Schematic Reference
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
With the scan tool, observe the Brake Switch Status data parameter. Apply and release the brake pedal. The brake pedal switch status should change from OFF to ON.
Circuit/System Testing
Important: Inspect for brake lamp related DTCs and symptoms before diagnosing DTC C0136.
Important: A binding brake pedal or improperly adjusted brake switch can cause DTC C0136 to set. Correct any hydraulic brake symptoms before diagnosing this DTC. Refer to
Symptoms - Hydraulic Brakes.
Disconnect the BCM harness connector X3. Connect a test lamp between the stop lamp switch signal circuit terminal 13 and ground. Apply the brake.
| ⇒ | If the test lamp does not illuminate but the center high mounted stop lamp (CHMSL) does illuminate, repair open in the stop lamp switch signal circuit. |
| ⇒ | If the test lamp and CHMSL illuminates, replace the BCM. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM and replacement, setup, and programming
