Warning: Refer to Brake Dust Warning in the Preface section.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement.
4. Remove the WSS cable mounting clip from the knuckle.
5. Remove the WSS cable mounting clip from the upper control arm.
6. Remove the WSS cable mounting clip from the frame attachment point.
7. Disconnect the WSS cable electrical connector.



8. Remove the wheel speed sensor (WSS) mounting bolt.

Caution: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.

9. Remove the wheel speed sensor (5) from the hub/bearing assembly (4).

1. Install the WSS (5) into the hub/bearing assembly (4).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the WSS mounting bolt.

Tighten
Tighten the WSS mounting bolt to 18 N·m (13 lb ft).




3. Install the WSS cable mounting clip to the knuckle.
4. Install the WSS cable mounting clip to the upper control arm.
5. Install the WSS cable mounting clip to the frame attachment point.
6. Connect the WSS cable electrical connector.
7. Install the brake rotor. Refer to Front Brake Rotor Replacement.
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
9. Return to Diagnostic Starting Point - Antilock Brake System.