Preliminary Procedure

Remove the engine protection shield. Refer to Engine Protection Shield Replacement.

1

Steering Linkage Shock Absorber Nut

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Separate the steering linkage shock absorber from the relay rod using puller J 24319-B .

Tip
Do not reuse the steering linkage shock absorber nut.

Tighten
40 N·m (30 lb ft)

Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

2

Steering Linkage Shock Absorber Nut

Tip
Do not reuse the steering linkage shock absorber nut.

Tighten
40 N·m (30 lb ft)

3

Steering Linkage Shock Absorber

Tip
Use installer J 29193 to seat the steering linkage shock absorber to the relay rod.

Tighten
32 N·m (24 lb ft)

Special Tools

J 29193 Steering Linkage Installer (12 mm)