GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2009 🢒 H2 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Rear Axle Shaft Replacement

Removal Procedure

    Object Number: 156409 Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement.
  4. Remove the rear cover and the gasket. Refer to Rear Axle Housing Cover and Gasket Replacement.
  5. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement.
  6. Remove the pinion shaft lock bolt.

    7. Object Number: 156410 Size: SH
  7. Remove the pinion shaft.

    8. Object Number: 391222 Size: SH
  8. Push the flange of the axle shaft (1) toward the differential.
  9. Remove the C-lock (4) from the button end of the axle shaft (1).

    10. Object Number: 913413 Size: SH

    Note: When removing the axle shaft, do not rotate the shaft. Rotating the shaft will misalign the gears. Misaligning the gears will make assembly difficult.

  10. Remove the axle shaft from the housing.

Installation Procedure

    Object Number: 913413 Size: SH

    Note: Carefully insert the axle shaft in order to not damage the seal.

  1. Install the axle shaft into the rear axle housing.
  2. Slide the axle shaft into place allowing the splines to engage the differential side gear.

    3. Object Number: 391222 Size: SH
  3. Place the lock (4) on the button end of the axle shaft (1).
  4. Pull the shaft flange outward in order to seat the lock in the differential gear.

    5. Object Number: 156409 Size: SH
  5. Align the hole in the pinion shaft with the bolt hole in the differential case.

    6. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the new pinion shaft locking bolt.

    7. Tighten
    Tighten the pinion shaft locking bolt to 53 N·m (39 lb ft).

  7. Install the rear cover and the gasket. Refer to Rear Axle Housing Cover and Gasket Replacement.
  8. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement.
  9. Install the brake rotor. Refer to Rear Brake Rotor Replacement.
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  11. Fill the rear axle. Refer to Rear Axle Lubricant Replacement.
  12. Lower the vehicle.